Toyota Highlander II facelift (2010-2013) transmission control ecu assembly (2.7l) (left front of engine) wiring diagram
This page shows the only wiring diagram for the component.transmission control ecu assembly (2.7l) (left front of engine), which is found in the car Toyota Highlander II facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
transmission control ecu assembly (2.7l) (left front of engine) wiring diagram (1 of 1)
3.5L
BLK WIRE
BLU WIRE
BRAKE FLUID LEVEL WARNING SWITCH (ON BRAKE MASTER CYLINDER RESERVOIR)
BRN WIRE
CLOCK ASSEMBLY
COMPUTER DATA LINES SYSTEM
DCTY
DISP
DOME FUSE
DOOR 1 FUSE
ECM (BEHIND RIGHT SIDE OF DASH)
ECU-B 1 FUSE
END OF DASH)
ENGINE ROOM R/B (LEFT SIDE OF ENGINE COMPT)
GAUGE FUEL GAUGE SENDER (IN FUEL TANK)
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR ACC
INSTRUMENT PANEL J/B (BEHIND LEFT
LCTY
LEFT FRONT DOOR COURTESY LIGHT SWITCH (IN LEFT "B" PILLAR)
LEFT REAR DOOR COURTESY LIGHT SWITCH (IN LEFT "C" PILLAR)
LEFT STEERING SWITCH
LT BLU WIRE
LT GRN WIRE
MAIN BODY ECU
NAVIGATION RECEIVER ASSEMBLY
PARKING BRAKE SWITCH (AT BASE OF PARKING BRAKE PEDAL)
PCTY
PNK WIRE
RADIO 2 FUSE
RADIO RECEIVER ASSEMBLY
RCTY
RED WIRE
RIGHT FRONT DOOR COURTESY LIGHT SWITCH (IN RIGHT "B" PILLAR)
RIGHT REAR DOOR COURTESY LIGHT SWITCH (IN RIGHT "C" PILLAR)
RIGHT STEERING SWITCH
SKID CONTROL ECU W/ ACTUATOR (RIGHT FRONT OF ENGINE COMPT)
SOUND, NAVIGATION SYSTEMS
SPIRAL CABLE ASSEMBLY (IN STEERING COLUMN)
STEERING PAD SWITCH ASSEMBLY
TIRE PRESSURE WARNING ECU (BEHIND RIGHT SIDE OF DASH)
TRANSMISSION CONTROL ECU ASSEMBLY (2.7L) (LEFT FRONT OF ENGINE)
VIO WIRE
W/ NAVIGATION
W/ POWER BACK DOOR W/O POWER BACK DOOR
W/ STEERING A/C SWITCH W/O STEERING A/C SWITCH
W/O NAVIGATION
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Instrument cluster circuit, except hybrid (2 of 2) -> TRANSMISSION CONTROL ECU ASSEMBLY (2.7L) (LEFT FRONT OF ENGINE)
