Toyota Highlander II facelift (2010-2013) (top right side of engine) noise filter (ignition bank 1) wiring diagram
This page shows the only wiring diagram for the component.(top right side of engine) noise filter (ignition bank 1), which is found in the car Toyota Highlander II facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(top right side of engine) noise filter (ignition bank 1) wiring diagram (1 of 1)
1 3 2 PNK PIM VC WIRE
BLK WIRE
BLK/WHT WIRE
BLU WIRE
BRN WIRE
CRANKSHAFT POSITION SENSOR (LEFT FRONT OF ENGINE)
ECM (RIGHT FRONT OF ENGINE COMPT)
EKNK
EPIM
GRN WIRE
IGF
KNOCK CONTROL SENSOR (BANK 2) (TOP CENTER OF ENGINE)
LT GRN WIRE
NCA WIRE
NE+
PIM
PNK WIRE
RED WIRE
THA
VPIM
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
YEL WIRE
Go to component -> Wiring diagram engine performance 3.5l hybrid, engine controls circuit (3 of 4) -> (TOP RIGHT SIDE OF ENGINE) NOISE FILTER (IGNITION BANK 1)
