Toyota Highlander II facelift (2010-2013) stop lp relay wiring diagram
This page shows the only wiring diagram for the component.stop lp relay, which is found in the car Toyota Highlander II facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
stop lp relay wiring diagram (1 of 1)
BLK WIRE
BLU WIRE
BM CANH HDCS FSW+
BRAKE PEDAL INTERIOR LOAD LIGHTS SENSING SYSTEM SWITCH (ABOVE BRAKE PEDAL)
BRN WIRE
CRUISE CONTROL SYSTEM
DLC 3 (UNDER LEFT SIDE OF DASH)
ECU-IG 2 FUSE
ENGINE ROOM R/B (LEFT SIDE OF ENGINE COMPT)
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
INSTRUMENT
INSTRUMENT PANEL J/B (BEHIND LEFT END OF DASH)
J/C
LEFT FRONT SPEED SENSOR (LEFT FRONT WHEEL HUB)
LEFT REAR SPEED SENSOR (LEFT REAR WHEEL HUB)
LT GRN WIRE
ORG/ WIRE
PARKING BRAKE SWITCH (AT BASE OF PARKING BRAKE PEDAL)
PKB CSW STPO
PNK WIRE
RED WIRE
RIGHT FRONT SPEED SENSOR (RIGHT FRONT WHEEL HUB)
RIGHT REAR SPEED SENSOR (RIGHT REAR WHEEL HUB)
RL- RL+ FR- FR+
RR- RR+ FL- FL+
SKID CONTROL ECU W/ ACTUATOR (RIGHT FRONT OF ENGINE COMPT)
STOP FUSE PANEL J/B (BEHIND LEFT END OF DASH)
STOP LIGHT SWITCH
STOP LP RELAY
TS CANL CANH
VIO WIRE
VSC 1 FUSE VSC 2 FUSE
VSC OFF SWITCH
WHT WIRE
WHT/BLK WIRE
Go to component -> Anti-lock brakes circuit, except hybrid (1 of 2) -> STOP LP RELAY
