Toyota Highlander II facelift (2010-2013) instrument cluster system gauge wiring diagram
This page shows the only wiring diagram for the component.instrument cluster system gauge, which is found in the car Toyota Highlander II facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
instrument cluster system gauge wiring diagram (1 of 1)
BLK WIRE
BLU WIRE
BRN WIRE
CANISTER PRESSURE SENSOR
DOME FUSE
ENGINE ROOM R/B (LEFT SIDE OF ENGINE COMPT)
EX+
EXHAUST SIDE) (RIGHT SIDE OF ENGINE)
FUEL PMP RELAY
FUEL PUMP
FUEL PUMP RESISTOR (RIGHT SIDE OF ENGINE COMPT)
FUEL SENDER GAUGE ASSEMBLY (IN FUEL TANK)
FUSE
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
HOT IN ON OR START INSTRUMENT IGN SIDE J/B FUSE (BEHIND LEFT END OF DASH)
INSTRUMENT CLUSTER SYSTEM GAUGE
INSTRUMENT SIDE J/B (BEHIND LEFT END OF DASH)
INTAKE SIDE) (RIGHT FRONT OF ENGINE)
LEAK DETECTION PUMP CANISTER PUMP MODULE (UNDER REAR OF VEHICLE)
LT BLU WIRE
LT GRN WIRE
ORG/ WIRE
PNK WIRE
RED WIRE
SFTD
SFTU
STOP FUSE
TRANSMISSION CONTROL SWITCH (UNDER CENTER CONSOLE)
VENT VALVE
VIO WIRE
VVR+
VVT SENSOR
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Wiring diagram engine performance 3.5l (2 of 6) -> INSTRUMENT CLUSTER SYSTEM GAUGE
