Toyota Highlander II facelift (2010-2013) engine control module (behind (right side wiring diagram
This page shows the only wiring diagram for the component.engine control module (behind (right side, which is found in the car Toyota Highlander II facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
engine control module (behind (right side wiring diagram (1 of 1)
+BM
10 30 50 ACM
BLK WIRE
BLU WIRE
BRN WIRE
E.F.I. ENGINE COOLANT TEMPERATURE SENSOR (REAR OF ENGINE)
ENGINE CONTROL MODULE (BEHIND (RIGHT SIDE
ENGINE ROOM
ETCS FUSE
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
IGF
IGNITION COIL ASSEMBLY 3 (TOP OF RIGHT CYLINDER BANK)
IGNITION COIL ASSEMBLY 4 (TOP OF LEFT CYLINDER BANK)
IGNITION COIL ASSEMBLY 5 (TOP OF RIGHT CYLINDER BANK)
IGNITION COIL ASSEMBLY 6 (TOP OF LEFT CYLINDER BANK)
INJ 1 INJ 2 R/B FUSE FUSE (LEFT SIDE OF ENGINE COMPT)
LT GRN WIRE
NC- NC+
NCA WIRE
NT- NT+
OF DASH)
PNK WIRE
REAR OF ENGINE COMPT)
RED WIRE
RED/BLU WIRE
STAR
STARTING/CHARGING SYSTEM
THW PRG ACIS AICV
VCTA ETA
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Wiring diagram engine performance 3.5l (6 of 6) -> ENGINE CONTROL MODULE (BEHIND (RIGHT SIDE
