Toyota Highlander II facelift (2010-2013) camshaft timining oil wiring diagram
This page shows the only wiring diagram for the component.camshaft timining oil, which is found in the car Toyota Highlander II facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
camshaft timining oil wiring diagram (1 of 1)
AIR FUEL RATIO SENSOR (BANK 1 SENSOR 1) (ON RIGHT EXHAUST MANIFOLD)
BLK WIRE
BLK/ WHT WIRE
BLU WIRE
BRN WIRE
CAMSHAFT TIMINING OIL
CONTROL VALVE (BANK 1 INTAKE) (TOP OF ENGINE)
GAUGE 2 FUSE
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
IGN FUSE
INSTRUMENT PANEL J/B (BEHIND LEFT END OF DASH)
KNOCK CONTROL SENSOR (BANK 1) (LEFT SIDE OF ENGINE)
LT BLU WIRE
LT GRN WIRE
NCA WIRE
ORG/ WIRE
OXYGEN SENSOR (BANK 1 SENSOR 2) (IN EXHAUST)
RED WIRE
STOP FUSE
VIO WIRE
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Wiring diagram engine performance 2.7l (2 of 5) -> CAMSHAFT TIMINING OIL
