Toyota Highlander I facelift (2003-2007) charcoal canister assembly wiring diagram
This page shows the only wiring diagram for the component.charcoal canister assembly, which is found in the car Toyota Highlander I facelift (2003-2007). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
charcoal canister assembly wiring diagram (1 of 1)
AF-
AIR FUEL RATIO SENSOR (BANK 1 SENSOR 1) (ON EXHAUST MANIFOLD)
BB (RIGHT CENTER PILLAR)
BC (LEFT SIDE OF REAR CROSSMEMBER)
BLK WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLU WIRE
BRN WIRE
CHARCOAL CANISTER ASSEMBLY
CIRCUIT OPENING RELAY
EE (INTAKE SIDE OF CYL BLOCK)
EFI 1 FUSE
EFI RELAY
EH (UNDER LEFT HEADLIGHT)
ENGINE ROOM J/B (ON LEFT SIDE OF ENGINE COMPT)
EXCD
FUEL PUMP (IN FUEL TANK)
GRN WIRE
GRY WIRE
HEATED OXYGEN SENSOR (BANK 1 SENSOR 2) (ON EXHAUST, AFTER CATALYTIC CONVERTER)
HOT AT ALL TIMES
J/C 19 (REAR OF VEHICLE)
J/C 2
J/C 7 (RIGHT SIDE OF DASH)
LT BLU WIRE
LT GRN WIRE
NCA WIRE
PNK 3 4 5 WIRE
PNK WIRE
PNK/BLU WIRE
R/B 1 (LEFT OF INSTRUMENT PANEL J/B)
RED WIRE
VIO WIRE
VOLTAGE INVERTER (W/ REAR SEAT ENTERTAINMENT SYSTEM) (CENTER OF VEHICLE)
WHT WIRE
WHT/BLK WIRE
YEL WIRE
YEL/GRN WIRE
Go to component -> Wiring diagram engine performance 2.4l (2 of 6) -> CHARCOAL CANISTER ASSEMBLY
