Toyota Corolla X facelift (2010-2013) (manual a/c) heater control base sub- assembly wiring diagram
This page shows the only wiring diagram for the component.(manual a/c) heater control base sub- assembly, which is found in the car Toyota Corolla X facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(manual a/c) heater control base sub- assembly wiring diagram (1 of 1)
A/C AMPLIFIER ASSEMBLY
AUTOMATIC A/C
BLK WIRE
BRN WIRE
CENTER AIR BAG SENSOR ASSEMBLY
COMBINATION METER ASSEMBLY
DLC 3
DOOR CONTROL RECEIVER
FLASHER RELAY
FROM J/B 4 (DIAGRAM 2 OF 3)
HAZARD TELLTALE WARNING LIGHT SIGNAL SWITCH ASSEMBLY ASSEMBLY
HAZARD WARNING SIGNAL SWITCH ASSEMBLY
HEADLIGHT DIMMER SWITCH ASSEMBLY
HEATER CONTROL SUB-ASSEMBLY
INSTRUMENT PANEL J/B (LEFT SIDE OF DASH)
J/B 4 (RIGHT SIDE OF DASH)
LEFT ECU FRONT 2 4 DOOR LOCK ASSEMBLY
LEFT RIGHT OUTER FRONT REAR SEAT HEATER VIEW ASSEMBLY MIRROR ASSEMBLY
MAIN BODY ECU
MANUAL A/C
MAP LIGHT ASSEMBLY
NOISE FILTER
OCCUPANT DETECTION +
OUTER MIRROR SWITCH ASSEMBLY
POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
PWR RELAY
RELAY
ROOM LIGHT ASSEMBLY 1
SEAT HEATER SWITCH
SHIFT LOCK CONTROL ECU SUB-ASSEMBLY
STEERING SENSOR
TELLTALE LIGHT ASSEMBLY
TIRE PRESSURE WARNING RESET SWITCH
TO J/B 4 (DIAGRAM 2 OF 3)
TRANSPONDER KEY ECU ASSEMBLY
UNLOCK WARNING SWITCH ASSEMBLY
VEHICLE STABILITY CONTROL SWITCH
VEHICLE STABILITY SEAT CONTROL HEATER SWITCH SWITCH
VIO WIRE
W/ RETRACTOR MIRROR
W/O DAYTIME RUNNING LIGHT
W/O RETRACTOR MIRROR
WHT WIRE
WHT/BLK WIRE
WIND- SHIELD WIPER SWITCH ASSEMBLY
YAW RATE SENSOR ASSEMBLY
Go to component -> Ground distribution circuit, tmc made (2 of 3) -> (MANUAL A/C) HEATER CONTROL BASE SUB- ASSEMBLY
