Toyota 4Runner V (2009-2013) canh canl lint wiring diagram
This page shows the only wiring diagram for the component.canh canl lint, which is found in the car Toyota 4Runner V (2009-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
canh canl lint wiring diagram (1 of 1)
+B IG LIN
A-TRAC IND
ABS IND.
AUTO LSD IND
BLK WIRE
BLK/RED WIRE
BLU WIRE
BLU/YEL WIRE
BRAKE IND
CANH CANL LINT
COMBINATION METER ASSEMBLY
COMPUTER DATA LINES SYSTEM
CONTROL IND ASSIST
CRAWL IND
DOWN HILL
DRIVE MONITOR SWITCH (W/ REAR DIFFERENTIAL LOCK)
DRIVER SIDE J/B MAIN BODY ECU
ECU-B FUSE
ENGINE ROOM R/B ASSEMBLY (LEFT SIDE OF ENGINE COMPARTMENT)
FOUR WHEEL DRIVE CONTROL ECU (RIGHT SIDE OF DASH)
GAUGE FUSE
GRN WIRE
HOT AT ALL TIMES
HOT IN ON OR START
J/B 4 (LEFT SIDE OF DASH)
J/B 5 (CENTER OF DASH)
LEFT REAR SPEED SENSOR
LT GRN WIRE
MGND
MULTI-TERRAIN SELECT IND
ORG/ WIRE
PARKING BRAKE SWITCH ASSEMBLY (UPPER LEFT END OF DASH)
RED WIRE
RLP CANH CANL 19 20 3 2
SLIP IND
STEERING SENSOR (LEFT SIDE OF DASH)
TRAC OFF IND
TRANSFER INDICATOR SWITCH
TRANSMISSION ASSEMBLY
VIO WIRE
VSC OFF
W/ REAR DIFFERENTIAL LOCK
WHT WIRE
WHT/BLK WIRE
YAW RATE SENSOR ASSEMBLY (BELOW FRONT OF CENTER CONSOLE)
Go to component -> Anti-lock brakes circuit (3 of 3) -> CANH CANL LINT
