Toyota 4Runner V (2009-2013) 31 32 29 canl canh tach wiring diagram
This page shows the only wiring diagram for the component.31 32 29 canl canh tach, which is found in the car Toyota 4Runner V (2009-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
31 32 29 canl canh tach wiring diagram (1 of 1)
1 4 5 RDA GND
31 32 29 CANL CANH TACH
BLK WIRE
BLU WIRE
BUZZER
COMBINATION METER ASSEMBLY
COMPUTER DATA LINES SYSTEM
DRIVER SIDE R/B ASSEMBLY (LEFT END OF DASH)
ECM (RIGHT END OF DASH)
ECU- IG 1 FUSE
ECU-B FUSE
ENGINE ROOM R/B ASSEMBLY (LEFT SIDE OF ENGINE COMPT)
GAUGE FUSE
GND SIL
GRN WIRE
GRN/WHT WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
J/B 4 (LEFT SIDE OF DASH)
J/B 5 (CENTER OF DASH)
LT BLU WIRE
LT GRN WIRE
MGND
PNK WIRE
RED WIRE
SKID CONTROL ECU W/ ACTUATOR ASSEMBLY (LEFT REAR OF ENGINE COMPT)
SPD TC TACH IND 3 4 5 6 7 8 9 10 11 12 PNK WIRE
TIRE PRESSURE IND
TIRE PRESSURE WARNING ANTENNA, RECEIVER (TOP CENTER REAR OF ROOF)
TIRE PRESSURE WARNING ECU (RIGHT SIDE OF DASH)
TIRE)
VIO WIRE
WHT WIRE
WHT/BLK WIRE
Go to component -> Tire pressure monitoring circuit -> 31 32 29 CANL CANH TACH
