Suzuki XL7 II (2006-2009) rear closure handle switch open signal Wiring diagram
This page shows the only wiring diagram for the component.rear closure handle switch open signal, which is found in the car Suzuki XL7 II (2006-2009). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram rear closure handle switch open signal (1 of 1)
BATT MAIN 2 FUSE 50
BLK WIRE
BLK/WHT WIRE
BODY CONTROL MODULE (BCM) (CENTER OF DASH, BEHIND HVAC CONTROL MODULE)
CLASS 2 (BCM)
CLASS 2 SERIAL DATA
COMPUTER DATA LINES SYSTEM
DK GRN WIRE
GMLAN SERIAL DATA
GROUND
GRY WIRE
HOT AT ALL TIMES
I/P FUSE BLOCK (CENTER OF DASH, BENEATH RIGHT
IGN
INSTRUMENT PANEL CLUSTER (IPC)
L/GATE FUSE 4
LIFTGATE AJAR SW
LIFTGATE IND
LIFTGATE LATCH RELAY COIL CONTROL
LIFTGATE LATCH RELAY SUPPLY VOLT
LIFTGATE PCB RELAY
LIFTGATE RELEASE ACTUATOR
LIFTGATE SWITCH
LOGIC
LT BLU WIRE
PNK/BLK WIRE
REAR CLOSURE HANDLE SWITCH OPEN SIGNAL
RED WIRE
SIDE OF RADIO)
UNDERHOOD FUSE BLOCK (LEFT SIDE OF ENGINE COMPT)
WIPER/ WASHER SYSTEM
YEL WIRE
Go to component -> Trunk, tailgate, fuel door circuit -> REAR CLOSURE HANDLE SWITCH OPEN SIGNAL
