Suzuki SX4 I facelift (2009-2014) keyless start control module Wiring diagram
This page shows the only wiring diagram for the component.keyless start control module, which is found in the car Suzuki SX4 I facelift (2009-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram keyless start control module (1 of 1)
A/B SDM (10 CH) (CENTER OF VEHICLE FLOOR)
ABS CONTROL MODULE (RIGHT REAR OF ENGINE COMPT)
BLK WIRE
BLK/ORG WIRE
BLU WIRE
BODY CONTROL MODULE (BCM) (LEFT SIDE OF DASH)
COMBINATION METER
CVT CONTROL MODULE
DLC (DATA LINK CONNECTOR) (BELOW LEFT SIDE OF DASH)
DOME FUSE
ENGINE CONTROL MODULE (ECM) (AT SIDE OF BATTERY)
ESP CONTROL MODULE (RIGHT REAR OF ENGINE COMPT)
HOT AT ALL TIMES
HVAC CONTROL MODULE (CENTER
ID CONTROL MODULE (IF EQUIPPED)
JUNCTION BLOCK ASSEMBLY (LEFT SIDE OF DASH)
KEYLESS START CONTROL MODULE
MODULE (CENTER OF DASH)
OF DASH)
RED WIRE
STEERING ANGLE SENSOR (W/ ESP) (IN STEERING COLUMN ASSEMBLY)
WHT WIRE
WHT/RED WIRE
YAW RATE/G SENSOR (W/ ESP)
Go to component -> Computer data lines circuit -> KEYLESS START CONTROL MODULE
