Suzuki Equator I (2008-2012) hill descent control switch wiring diagram
This page shows the only wiring diagram for the component.hill descent control switch, which is found in the car Suzuki Equator I (2008-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
hill descent control switch wiring diagram (1 of 1)
12 11 23 13 PNK WIRE
2 8 3 4 1 PWR BATT CAN-H CAN-L GND
3 2 1 5 CLU P CAN-H CAN-L CLU_GND
ABS IND.
BLK WIRE
BLU WIRE
BRAKE FLUID LEVEL SWITCH
BRAKE IND
BRN WIRE
COMBINATION METER
COMPUTER DATA LINES SYSTEM
FUSE 14
FUSE 21
FUSE BLOCK (J/B) (UNDER RIGHT SIDE OF DASH)
FUSE, FUSIBLE LINK BOX (LEFT REAR ENGINE COMPT)
FUSIBLE LINK L
FUSIBLE LINK N
GRN WIRE
GRY WIRE
HILL DESCENT CONTROL IND
HILL DESCENT CONTROL SWITCH
HOT AT ALL TIMES
HOT IN ON OR START
INSTRUMENT CLUSTER SYSTEM
LT BLU WIRE
ORG/ WIRE
PNK WIRE
RED WIRE
SLIP IND
STEERING ANGLE SENSOR
UNIFIED METER CONTROL UNIT
VDC OFF IND
VDC OFF SWITCH
WHT WIRE
WHT/GRN WIRE
WHT/RED WIRE
YAW RATE/SIDE/DECEL G SENSOR
YEL WIRE
Go to component -> Anti-lock brakes circuit, with vdc (2 of 2) -> HILL DESCENT CONTROL SWITCH
