Suzuki Equator I (2008-2012) control and hill wiring diagram

+IG 70 67 GND (PWR) BAT (F/L) A/T SHIFT RIGHT FRONT HEATED SEAT SWITCH (IF ASSIST) AUDIO UNIT (IF EQUIPPED) BCM (BODY CONTROL MODULE) (RIGHT SIDE OF STEERING COLUMN UNDER DASH) BLK WIRE BLU WIRE BRN WIRE CAN-H CARGO LAMP SWITCH CLUTCH GLOVE INTERLOCK BOX CANCEL LAMP SWITCH (IF EQUIPPED) COMB SW IN 1 COMB SW IN 2 COMB SW IN 4 COMB SW OUT 1 COMB SW OUT 2 COMB SW OUT 3 COMB SW OUT 4 COMB SW OUT 5 COMBINATION METER COMBINATION SWITCH (LIGHTING, TURN SIGNAL SWITCH) COMBINATION SWITCH (SPIRAL CABLE) COMPUTER DATA LINES SYSTEM COMPUTER DATA LINES SYSTEM (4.0L) CONTROL CONTROL AND HILL CPU TAIL/L RLY FUSE DIFFERENTIAL LOCK MODE SWITCH (W/ ELECTRONIC DOOR MIRROR REMOTE CONTROL SWITCH (W/ POWER OUTSIDE MIRRORS) ELECTRIC BRAKE (PRE-WIRING) EQUIPPED) FUSE 1 FUSE FUSE GND (SIG) CAN-L CAN-H GND PWR GRN WIRE GRY WIRE HAZARD SWITCH PNK WIRE HILL DESCENT HILL DESCENT CONTROL SWITCH (W/ HOT AT ALL TIMES HOT AT ALL TIMES FUSE BLOCK (J/B) (UNDER RIGHT SIDE OF DASH) FUSE 19 HOT AT ALL TIMES FUSE, FUSIBLE LINK BOX FUSIBLE LINK G (LEFT REAR ENGINE COMPT) HOT IN ON OR START IGN SW IGNITION RELAY INPUT 1 INPUT 2 INPUT 3 INPUT 4 INPUT 5 IPDM E/R (LEFT REAR ENGINE COMPT) TAIL LAMP RELAY LEFT FRONT HEATED SEAT SWITCH (IF FRONT AIR LOCKING REAR DIFFERENTIAL) LT BLU WIRE LT GRN WIRE METER ILLUM ORG/ WIRE OUTPUT 1 OUTPUT 2 OUTPUT 4 PNK CAN-L WIRE PNK COMB SW IN 5 WIRE PNK OUTPUT 5 WIRE PNK WIRE PPL PPL COMB SW IN 3 PPL OUTPUT 3 RED WIRE RED/YEL WIRE SELECTOR (W/ A/T) SHIFT SWITCH (4 WHEEL DRIVE) UNIFIED METER CONTROL UNIT (W/ INFORMATION DISPLAY) VDC OFF SWITCH (W/ VDC) WHT WIRE WHT/RED WIRE