Subaru XV GP (2011-2016) remote engine start control module wiring diagram
This page shows the only wiring diagram for the component.remote engine start control module, which is found in the car Subaru XV GP (2011-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
remote engine start control module wiring diagram (1 of 1)
ACTIVE GRILLE SHUTTER
AIR BAG CONTROL MODULE
AT SELECT LEVER
BATTERY
BEAM LEVELER CONTROL MODULE
BLK WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU/YEL WIRE
BODY INTEGRATED UNIT
BRAKE FLUID FRONT LEVEL WIPER SWITCH MOTOR
BRAKE STROKE SENSOR SHIELD
COMBINATION SWITCH (LIGHTING)
COMBINATION SWITCH (WIPER)
FUSE OUTPUT BLOCK CLUTCH KEY (F/B) RELAY LOCK
GAP (TOP REAR OF ENGINE)
GB-1 (NEAR RIGHT HEADLIGHT)
GB-2 (NEAR LEFT HEADLIGHT)
GB-3 (RIGHT END OF DASH)
GB-4 (CENTER OF DASH)
GB-5 (CENTER OF DASH)
GB-6 (LEFT END OF DASH)
GRN RED/ WIRE
GRN/RED WIRE
GV (RIGHT FRONT OF ENGINE COMPT)
HOOD SWITCH
HPCM
IG IG RELAY RELAY 2 RELAY 1
IMPACT SENSOR
INHIBITOR SWITCH
J/C
KEYLESS BUZZER
LEFT FRONT COMBINATION LIGHT
LEFT FRONT FOG LIGHT
LEFT HI-BEAM
LT BLU WIRE
MAIN FAN MOTOR
MAIN FAN RELAY 2
NCA WIRE
PADDLE SHIFT SWITCH
POWER STEERING CONTROL MODULE
POWER TRANSISTOR
POWER WINDOW RELAY
PRESSURE SWITCH
REARVIEW MIRROR)
RELAY HOLDER
REMOTE ENGINE START CONTROL MODULE
RIGHT FRONT COMBINATION LIGHT
RIGHT FRONT FOG LIGHT
RIGHT HI-BEAM
ROLL CONNECTOR
SEAT HEATER RELAY
SPOT ROOM MAP LIGHT LIGHT
STARTER
STEERING ANGLE SENSOR AUTO HEAD- LIGHT
STEERING SWITCH
SUNROOF MOTOR ASSEMBLY (IF EQUIPPED)
TURN SIGNAL, HAZARD ACCESSORY MODULE RELAY
VDC CONTROL MODULE
W/ PUSH BUTTON START W/ ID CODE BOX 4 5
W/ SUNROOF W/O SUNROOF
WASHER FLUID LEVEL SENSOR
WIPER BATTERY RELAY RELAY
WIPER DEICER
YEL WIRE
Go to component -> Ground distribution circuit, with hev (1 of 3) -> REMOTE ENGINE START CONTROL MODULE
