Subaru Tribeca WX facelift (2007-2014) low-washer fluid warning light indicator Wiring diagram
This page shows the only wiring diagram for the component.low-washer fluid warning light indicator, which is found in the car Subaru Tribeca WX facelift (2007-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram low-washer fluid warning light indicator (1 of 1)
BLK WIRE
BLK/BLU WIRE
BLK/YEL WIRE
BLU WIRE
BODY INTEGRATED UNIT (UNDER FRONT OF CENTER CONSOLE)
BRN/WHT WIRE
COMBINATION METER
COMBINATION SWITCH (FRONT WIPER, WASHER SWITCH)
DRIVE CIRCUIT
FRONT WASHER MOTOR (IN WASHER RESERVOIR)
FRONT WASHER SWITCH ON
FRONT WIPER MOTOR (LEFT SIDE OF FIREWALL)
FUSE
FUSE (LEFT END OF DASH)
FUSE, RELAY BOX (F/B) (LEFT END OF DASH)
GB-11 (UNDER CENTER CONSOLE)
GB-6 (CENTER OF DASH)
GB-7 (RIGHT KICK PANEL)
GRN WIRE
GRN/YEL WIRE
HI LO
HOT IN ON OR ACC
HOT IN ON OR START
INT OFF
INTERMITTENT UNIT
INTERMITTENT VOLUME
LO INT OFF FRONT WIPER SWITCH HI LO
LOW-WASHER FLUID WARNING LIGHT INDICATOR
MICRO COMPUTER
MIST MIST SWITCH
NCA WIRE
OFF
OFF HI
RED WIRE
RED/BLU WIRE
RELAY BLOCK
RESERVOIR)
VDC CONTROL MODULE (RIGHT REAR CORNER OF ENGINE COMPT)
WASHER LEVEL SWITCH (IN WASHER
WIPER MOTOR
WIPER RELAY UNIT (LEFT SIDE OF DASH)
YEL/BLK WIRE
YEL/BLU WIRE
Go to component -> Front wiper/washer circuit -> LOW-WASHER FLUID WARNING LIGHT INDICATOR
