Subaru Outback BR facelift (2012-2014) washer level sensor (in washer fluid reservoir) wiring diagram
This page shows the only wiring diagram for the component.washer level sensor (in washer fluid reservoir), which is found in the car Subaru Outback BR facelift (2012-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
washer level sensor (in washer fluid reservoir) wiring diagram (1 of 1)
BLK WIRE
BLK/YEL WIRE
BLU WIRE
BLU/WHT WIRE
BODY INTEGRATED UNIT
BODY INTEGRATED UNIT (CENTER OF DASH)
BRN WIRE
BRN/WHT WIRE
BRN/YEL WIRE
COMBINATION METER
COMBINATION SWITCH
COMBINATION SWITCH (REAR WIPER, WASHER SWITCH)
COMPUTER DATA LINES SYSTEM
DRIVE CIRCUIT
FUSE
FUSE 26
FUSE 27
FUSE 5
FUSE, RELAY BOX (F/B)
FUSE, RELAY BOX (F/B) (LEFT KICK PANEL)
GB-5
GB-5 (RIGHT KICK PANEL)
GB-8
GB-8 (BASE OF RIGHT "B" PILLAR)
GRN WIRE
GRN/ORG WIRE
GRN/RED WIRE
HI LO
HI LO OFF
HI LO OFF ON+WASH WASH
HOT AT ALL TIMES
HOT IN ON OR START
LOW-WASHER FLUID WARNING LIGHT INDICATOR
LT GRN WIRE
LUMINESCENT METER
MAIN FUSE BLOCK (M/B)
MAIN FUSE BLOCK (M/B) (LEFT SIDE OF ENGINE COMPT)
MAIN SBF FUSE
MICRO COMPUTER
NCA WIRE
OFF
OFF LO
ON+WASH
ON+WASH WASH
ORG/ WIRE
REAR WASHER MOTOR
REAR WASHER MOTOR (LEFT FRONT OF ENGINE COMPT)
REAR WIPER MOTOR
REAR WIPER MOTOR (IN REAR GATE)
REAR WIPER/ WASHER SWITCH
RED WIRE
WASH
WASHER LEVEL SENSOR
WASHER LEVEL SENSOR (IN WASHER FLUID RESERVOIR)
WHT WIRE
WHT/BLU WIRE
WIPER RELAY
Go to component -> Rear wiper/washer circuit -> WASHER LEVEL SENSOR (IN WASHER FLUID RESERVOIR)
