Subaru Outback BR (2009-2012) (right end of dash) impact sensor wiring diagram
This page shows the only wiring diagram for the component.(right end of dash) impact sensor, which is found in the car Subaru Outback BR (2009-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(right end of dash) impact sensor wiring diagram (1 of 1)
A/C CONTROL MODULE (BEHIND RIGHT SIDE OF DASH)
A/T CVT
ACCELERATOR PEDAL POSITION SENSOR SHIELD
BLK WIRE
BLK/BLU WIRE
BLK/GRN WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU WIRE
BODY INTEGRATED UNIT (CENTER OF DASH)
COMBINATION METER
CRUISE CONTROL SWITCH
DATA LINK CONNECTOR (LEFT END OF DASH)
DELIVERY (TEST) MODE FUSE 36
ECM (RIGHT SIDE OF DASH)
ELECTRONIC THROTTLE CONTROL SHIELD
EPB CONTROL MODULE (UNDER REAR SEAT)
FUSE
GRN/YEL WIRE
HOT AT ALL TIMES MAIN FUSE BOX (M/B)
HOT IN ON OR START FUSE, RELAY BOX (F/B) (LEFT KICK PANEL)
NCA WIRE
NEUTRAL POSITION SWITCH (M/T)
PNK WIRE
RED WIRE
REMOTE ENGINE START CONTROL MODULE (LEFT SIDE OF DASH)
ROLL CONNECTOR (LEFT SIDE OF DASH)
SECURITY CONTROL MODULE (IF EQUIPPED) (RIGHT KICK PANEL)
STEERING ANGLE SENSOR (STEERING COLUMN)
TCM (LEFT SIDE OF DASH)
VIO/RED WIRE
WHT WIRE
Go to component -> Computer data lines circuit -> (RIGHT END OF DASH) IMPACT SENSOR
