Subaru Outback BR (2009-2012) control valve body ground Wiring diagram
This page shows the only wiring diagram for the component.control valve body ground, which is found in the car Subaru Outback BR (2009-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram control valve body ground (1 of 1)
AIR BAG CONTROL MODULE
BLK WIRE
BLK/BLU WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLK/YEL WIRE
CAMSHAFT POSITION SENSOR SHIELD
CONTROL VALVE BODY GROUND
CRANKSHAFT POSITION SENSOR SHIELD
ELECTRONIC THROTTLE CONTROL SHIELD
FRONT OXYGEN (A/F) SENSOR
GAB-1 (CENTER OF DASH)
GAB-2 (RIGHT END OF DASH)
GE-1 (2.5L N0N-TURBO) (TOP CENTER OF ENGINE)
GE-2 (2.5L N0N-TURBO) (TOP CENTER OF ENGINE)
GV (RIGHT FRONT OF ENGINE COMPT)
JOINT CONNECTOR
KNOCK SENSOR SHIELD
M/T
ORG/ WIRE
ORG/BLK WIRE
ORG/GRN WIRE
PCV DIAGNOSIS CONNECTOR
PNK/BLK WIRE
PNK/BLU WIRE
PNK/WHT WIRE
REAR OXYGEN SENSOR
RED WIRE
SECONDARY AIR PUMP (2.5L TURBO)
TCM
VDC CONTROL MODULE
Go to component -> Ground distribution circuit, except wrx sti (3 of 3) -> CONTROL VALVE BODY GROUND
