Subaru Outback BP (2003-2006) shield and sensor ground joint connector Wiring diagram
This page shows the only wiring diagram for the component.shield and sensor ground joint connector, which is found in the car Subaru Outback BP (2003-2006). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram shield and sensor ground joint connector (1 of 1)
BLK WIRE
BLK/BLU WIRE
BLK/GRN WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLK/YEL WIRE
COMBINATION METER
CRANKSHAFT POSITION SENSOR SHIELD CAMSHAFT POSITION SENSOR SHIELD
DATA LINK CONNECTOR
DIAGNOSIS TERMINAL
ENGINE CONTROL MODULE (2.5L TURBO)
ENGINE CONTROL MODULE (2.5L)
ENGINE CONTROL MODULE (W/ TURBO ENGINE)
FUEL LEVEL SENSOR
GE-1 (2.5L TURBO) (TOP LEFT SIDE OF ENGINE)
GE-1 (2.5L) (TOP LEFT SIDE OF ENGINE)
GE-1 (W/ TURBO ENGINE) (TOP LEFT SIDE OF ENGINE)
GRN WIRE
GRN/WHT WIRE
IDLE AIR CONTROL SOLENOID VALVE
IGNITION COIL 1
IGNITION COIL 1 PCV DIAGNOSIS CONNECTOR
IGNITION COIL 2
IGNITION COIL 3
IGNITION COIL 4
IGNITION COIL, IGNITOR
KNOCK SENSOR SHIELD
M/T
NEUTRAL POSITION SWITCH (M/T)
PCV DIAGNOSIS CONNECTOR
RED WIRE
SHIELD AND SENSOR GROUND JOINT CONNECTOR
TEST MODE CONNECTOR
VEHICLE SPEED SENSOR (M/T)
WHT WIRE
Go to component -> Ground distribution circuit (3 of 3) -> SHIELD AND SENSOR GROUND JOINT CONNECTOR
