Subaru Legacy BM/BR (2009-2012) rear oxygen sensor shield Wiring diagram
This page shows the only wiring diagram for the component.rear oxygen sensor shield, which is found in the car Subaru Legacy BM/BR (2009-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram rear oxygen sensor shield (1 of 1)
2.5L NON- TURBO
BLK WIRE
BLK/BLU WIRE
BLK/PNK WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU/RED WIRE
BRN WIRE
CRANKSHAFT POSITION SENSOR SHIELD
CVT
ELECTRONIC THROTTLE CONTROL SHIELD
FRONT OXYGEN (A/F) KNOCK SENSOR SENSOR SHIELD SHIELD
GB-11 (OUTBACK) (RIGHT TOP OF REAR GATE)
GB-7 (SEDAN: CENTER FRONT OF LUGGAGE COMPT) (WAGON: RIGHT QUARTERPANEL)
GB-8 (BASE OF RIGHT "B" PILLAR)
IGNITION COIL
LEFT REAR FINISHER LIGHT (SEDAN) (BACKUP REAR LIGHT) DEFOGGER
LEFT REAR FINISHER LIGHT (TAIL LIGHT)
LEFT RIGHT REAR REAR FINISHER COMBINATION LIGHT LIGHT (TAIL (TAIL LIGHT) LIGHT)
LUGGAGE ROOM LIGHT
NAVIGATION UNIT SHIELD
NCA WIRE
ORG/ WIRE
ORG/BLK WIRE
PNK WIRE
REAR LICENSE REAR WIPER PLATE DEFOGGER MOTOR LIGHT
REAR OXYGEN SENSOR SHIELD
REARVIEW CAMERA SHIELD
RED WIRE
RIGHT
RIGHT REAR FINISHER LIGHT
RIGHT REAR FINISHER LIGHT (BACKUP LIGHT)
RIGHT REAR POWER WINDOW SUB SWITCH
RIGHT RIGHT FRONT
SEDAN
TCM
YEL GRN/ WIRE
YEL WIRE
Go to component -> Ground distribution circuit (3 of 3) -> REAR OXYGEN SENSOR SHIELD
