Subaru Legacy BL/BP facelift (2006-2009) pressure switch wiper deicer Wiring diagram
This page shows the only wiring diagram for the component.pressure switch wiper deicer, which is found in the car Subaru Legacy BL/BP facelift (2006-2009). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram pressure switch wiper deicer (1 of 1)
ABS CONTROL MODULE
AT SELECT LEVER
AUTO A/C CONTROL MODULE
AUTOMATIC A/C CONTROL MODULE
BLK WIRE
BLK/YEL WIRE
BODY INTEGRATED UNIT
BRAKE FLUID LEVEL SWITCH
COMBINATION SWITCH (LIGHTING)
COMBINATION SWITCH (WIPER)
CONTROL UNIT)
DAY TIME RUNNING LIGHT RELAY
DAYTIME RUNNING LIGHT CONTROL MODULE
FRONT WIPER MOTOR
FUEL PUMP ROLL RELAY CONNECTOR
GA (RIGHT SIDE OF ENGINE COMPT)
GB-4 (AT REAR OF ENGINE COMPT)
GB-5 (RIGHT SIDE OF DASH)
GB-6 (CENTER OF DASH)
GB-7 (RIGHT SIDE OF DASH)
GB-8 (WAGON: UNDER FRONT PASSENGER SEAT) (SEDAN: UNDER RIGHT FRONT SEAT)
GRN/RED WIRE
GV (RIGHT SIDE OF ENGINE COMPT)
LEFT FRONT FRONT DOOR DOOR KEY LOCK SOLENOID AT SELECT LEVER SWITCH SWITCH
PRESSURE SWITCH WIPER DEICER
RELAY BOX (F/B)
REMOTE ENGINE
RIGHT
RIGHT VANITY MIRROR ILLUMINATION LIGHT
ROOM LIGHT
SEAT BELT, AIR BAG WARNING LIGHT
SEAT HEATER RELAY POWER WINDOW RELAY MIRROR HEATER RELAY
SHADE MIRROR
SPOT MAP LIGHT
TEST MODE CONNECTOR
TO GB-3 (DIAGRAM 3 OF 3)
TO GB-9 (DIAGRAM 3 OF 3)
TPM NAVIGATION CONTROL MODULE IMPACT SENSOR CONTROL MODULE
TURN SIGNAL, HAZARD MODULE
VANITY MIRROR ILLUMINATION LIGHT
VDC CONTROL MODULE
WAGON
YAW RATE SENSOR
Go to component -> Ground distribution circuit (2 of 3) -> PRESSURE SWITCH WIPER DEICER
