Subaru Impreza GC/GF (1992-2000) pressure switch wiring diagram
This page shows the only wiring diagram for the component.pressure switch, which is found in the car Subaru Impreza GC/GF (1992-2000). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
pressure switch wiring diagram (1 of 1)
A/C RELAY HOLDER FUSE 15
A/C SWITCH
AIR CONDITIONER FUSE
AIR CONDITIONING RELAY (IN A/C RELAY HOLDER)
BLK WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLOWER MOTOR
BLOWER MOTOR RELAY (BEHIND LEFT SIDE OF DASH)
BLOWER MOTOR RESISTOR (BEHIND RIGHT SIDE OF DASH)
BRN/RED WIRE
BRN/YEL WIRE
CLUTCH/ THERMAL PROTECTOR
COMPRESSOR)
DIODE (A/C) (BEHIND LEFT SIDE OF DASH)
ENGINE CONTROL MODULE AIR CONDITIONING CUT RELAY (RIGHT SIDE OF FIREWALL)
EVAPORATION THERMOSWITCH
FAN SWITCH
FUSE 13 FUSE 21
FUSE 20
FUSE AND RELAY BOX
GRN WIRE
GRN/RED WIRE
GRN/WHT WIRE
HOT AT ALL TIMES
HOT IN ON OR START
IGNITION SWITCH
MAIN FAN MOTOR
MAIN FAN RELAY
MH HI
MODE CONTROL PANEL
NCA WIRE
OF DASH)
OFF
OFF LO ML
OFF LO ML MH HI
PRESSURE SWITCH
RED WIRE
RED/BLK WIRE
RED/BLU WIRE
RED/GRN WIRE
RED/WHT WIRE
RED/YEL WIRE
RUN WIRE
SUB FAN MOTOR
SUB-FAN RELAY (IN A/C RELAY HOLDER)
WHT WIRE
WHT/YEL WIRE
YEL WIRE
YEL/BLK WIRE
YEL/BLU WIRE
YEL/GRN WIRE
YEL/RED WIRE
Go to component -> A/c circuit -> PRESSURE SWITCH
