Scion xB II (2007-2010) pre sol+ ig+ sblw te sg-3 gnd Wiring diagram
This page shows the only wiring diagram for the component.pre sol+ ig+ sblw te sg-3 gnd, which is found in the car Scion xB II (2007-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram pre sol+ ig+ sblw te sg-3 gnd (1 of 1)
A/C AMPLIFIER (CENTER OF DASH)
A/C COMPRESSOR
A/C LED
A/C PRESSURE SENSOR (RIGHT REAR OF ENGINE COMPT)
A/C THERMISTOR (RIGHT SIDE OF DASH)
BLK WIRE
BLU WIRE
BLU/WHT WIRE
BRN WIRE
CANH CANL SG-2
CRANKSHAFT POSITION SENSOR (ON LOWER FRONT OF ENGINE)
ECU-IG 2 FUSE
ENGINE CONTROL MODULE (LEFT SIDE OF ENGINE COMPT)
ENGINE ROOM J/B (LEFT SIDE OF ENGINE COMPT)
FAN CAN CAN FAN ETHW THW
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
HTR FUSE
HTR RELAY
HTR-IG FUSE
INSTRUMENT PANEL J/B (BEHIND LEFT SIDE OF DASH)
J/B 4 (CENTER OF DASH)
LT GRN WIRE
NCA WIRE
NE- NE+
ORG/ WIRE
PNK WIRE
PRE SOL+ IG+ SBLW TE SG-3 GND
RED WIRE
SOL- SOL+
VIO WIRE
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Manual a/c circuit (1 of 2) -> PRE SOL+ IG+ SBLW TE SG-3 GND
