Scion tC II (2010-2013) compressor assembly with pulley Wiring diagram
This page shows the only wiring diagram for the component.compressor assembly with pulley, which is found in the car Scion tC II (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram compressor assembly with pulley (1 of 1)
AIR FUEL RATIO SENSOR (BANK 1 SENSOR 1) SHIELD
BLK WIRE
BRAKE FLUID LEVEL WARNING SWITCH (BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY)
BRN WIRE
CANISTER PUMP DLC 3 MODULE
COMPRESSOR ASSEMBLY WITH PULLEY
COOLING FAN MOTOR 1
CRANK POSITION SENSOR SHIELD
CRUISE CONTROL MAIN SWITCH
DEF RELAY
EFI 1 RELAY
EFI 2 RELAY
ENGINE CONTROL MODULE
ENGINE CONTROL MODULE (ECM)
FAN 2 RELAY
GRN WIRE
IGNITION COIL
KNOCK CONTROL SENSOR (BANK 1) SHIELD
LEFT FRONT PARKING LIGHT, SIDE MARKER LIGHT (LEFT HEADLIGHT ASSEMBLY)
LEFT FRONT TURN SIGNAL LIGHT (LEFT HEADLIGHT ASSEMBLY)
LEFT HEADLIGHT ASSEMBLY
LEVEL WARNING SWITCH ASSEMBLY
NCA WIRE
OPTION CONNECTOR (ENGINE HOOD COURTESY SWITCH ASSEMBLY)
OXYGEN SENSOR (BANK 1 SENSOR 2) SHIELD
POWER STEERING ECU ASSEMBLY
RELAY
RIGHT FRONT PARKING LIGHT, SIDE MARKER LIGHT (RIGHT HEADLIGHT ASSEMBLY)
RIGHT FRONT TURN SIGNAL LIGHT (RIGHT HEADLIGHT ASSEMBLY)
RIGHT HEADLIGHT ASSEMBLY
SPIRAL CABLE SUB-ASSEMBLY
STEERING PAD SWITCH
VSC ACTUATOR ASSEMBLY
WHT/BLK WIRE
WINDSHIELD WIPER MOTOR ASSEMBLY
WIRELESS DOOR LOCK BUZZER
Go to component -> Ground distribution circuit (1 of 3) -> COMPRESSOR ASSEMBLY WITH PULLEY
