Saab 9-7X I (2005-2009) rear sig hi rear sig lo Wiring diagram
This page shows the only wiring diagram for the component.rear sig hi rear sig lo, which is found in the car Saab 9-7X I (2005-2009). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram rear sig hi rear sig lo (1 of 1)
850 1640 1552 1553 GROUND BATTERY MOTOR CTRL A MOTOR CTRL B
ATC FUSE 8
BLK WIRE
BLK/WHT WIRE
BRN/WHT WIRE
CLASS 2 DATA
COMPUTER DATA LINES SYSTEM
DK GRN WIRE
DK GRN/WHT WIRE
ENCODER
ENCODER SIG
GROUND
GRY WIRE
HOT AT ALL TIMES
HOT IN RUN OR START
I/P HARNESS PASS-THROUGH)
IGN E FUSE 22
IND
INSTRUMENT PANEL CLUSTER (IPC)
LOGIC
LOW REF
LT BLU WIRE
NCA WIRE
NEAR HEADLAMP SWITCH CONNECTOR) SPLICE PACK
ORG/ WIRE
PNK WIRE
PPL
PPL DATA LINK CONNECTOR (ON BOTTOM LEFT SIDE OF DASH)
PPL FRONT SIG LO FRONT SIG HI
PROPSHAFT SPEED SENSOR (LEFT FRONT) (ON LEFT FRONT OF TRANSFER CASE)
REAR SIG HI REAR SIG LO
RED WIRE
SERVICE
TRANSFER CASE SHIFT CONTROL MODULE (BEHIND LOWER LEFT SIDE OF DASH)
UNDERHOOD FUSE BLOCK (ON LEFT SIDE OF ENGINE COMPT)
YEL WIRE
Go to component -> Transfer case circuit -> REAR SIG HI REAR SIG LO
