Saab 9-5 II (2010-2012) (engine harness, on breakout to Wiring diagram
This page shows the only wiring diagram for the component.(engine harness, on breakout to, which is found in the car Saab 9-5 II (2010-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram (engine harness, on breakout to (1 of 1)
2.0L 2.0L
2.0L 2.8L
2.8L
BACKUP LAMP SWITCH (M/T)
BLK WIRE
BLK/WHT WIRE
BODY CONTROL MODULE
BREAKOUT TO
COOLING FAN MOTOR (W/ SINGLE FAN)
COOLING FAN RELAY
ELECTRONIC BRAKE CONTROL MODULE
ENGINE COMPT) STARTER RELAY
ENGINE COMPT, FORWARD OF BATTERY)
ENGINE CONTROL MODULE
FROM SPLICE
FUEL COMPOSITION SENSOR (2.0L)
HEADLAMP WASHER FLUID PUMP
HEADLAMP WASHER FLUID PUMP RELAY
IGNITION COIL 1
IGNITION COIL 2
IGNITION IGNITION COIL 4 COIL 6
IGNITION MAIN RELAY
MASS AIR FLOW/ INTAKE AIR TEMPERATURE SENSOR (2.0L)
REAR COMPARTMENT LID RELEASE RELAY
REAR DEFOGGER RELAY
RIGHT COOLING FAN MOTOR (W/ DUAL FAN)
SECONDARY AIR INJECTION PUMP
SECONDARY AIR INJECTION PUMP RELAY
SECURITY DOOR LOCK RELAY (IF EQUIPPED)
UNDERHOOD FUSE BLOCK
UNDERHOOD FUSE BLOCK (LEFT SIDE OF
UNDERHOOD FUSE BLOCK (LEFT SIDE OF ENGINE COMPT)
WINDSHIELD WASHER FLUID LEVEL SENSOR
WINDSHIELD WASHER PUMP
WINDSHIELD WIPER RELAY
WINSHIELD WASHER PUMP RELAY
Go to component -> Ground distribution circuit (2 of 8) -> (ENGINE HARNESS, ON BREAKOUT TO
