Saab 9-5 I facelift 2 (2005-2010) front passenger seat belt force sensor Wiring diagram
This page shows the only wiring diagram for the component.front passenger seat belt force sensor, which is found in the car Saab 9-5 I facelift 2 (2005-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram front passenger seat belt force sensor (1 of 1)
ACC CONTROL MODULE
AIR BAG INDICATOR
BLK WIRE
BLK/ORG WIRE
BLK/WHT WIRE
BLU WIRE
BRN WIRE
DASHBOARD MAIN FUSE BOARD
FRONT PASSENGER LOADED SEAT CUSHION PRESSURE SENSOR (IN SEAT CUSHION)
FRONT PASSENGER SEAT BELT FORCE SENSOR
FUSE 27 (BEHIND LEFT END OF DASH)
FUSE 28
GRN WIRE
GRY WIRE
HOT IN RUN OR START
MAIN INSTRUMENT UNIT
NCA WIRE
OFF ON
ORG/ WIRE
ORG/BLU WIRE
ORG/VIO WIRE
ORG/WHT WIRE
PASSENGER AIR BAG (BEHIND RIGHT SIDE OF DASH)
PASSENGER AIR BAG IND
PPS CONTROL MODULE (UNDER SEAT CUSHION)
RED WIRE
SOLID STATE
VIO WIRE
VIO/BLU WIRE
VIO/BRN WIRE
VIO/GRY WIRE
WHT WIRE
YEL WIRE
Go to component -> Supplemental restraints circuit (2 of 2) -> FRONT PASSENGER SEAT BELT FORCE SENSOR
