Saab 9-3 I (1998-2003) glass breakage sensor (in center roof light console) wiring diagram
This page shows the only wiring diagram for the component.glass breakage sensor (in center roof light console), which is found in the car Saab 9-3 I (1998-2003). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
glass breakage sensor (in center roof light console) wiring diagram (1 of 1)
ANGLE SENSOR (ON FLOOR TUNNEL, IN FRONT OF AIR BAG CONTROL MODULE)
ANTI- THEFT ALARM LED
ANTI- THEFT ALARM SIREN
ANTI-THEFT ALARM BONNET SWITCH (LEFT SIDE OF ENG COMPT, BY MAIN FUSE BOX)
BLK WIRE
BLK/GRN WIRE
BLK/GRY WIRE
BLK/WHT WIRE
BLU/WHT WIRE
BRN WIRE
DRIVER'S CENTRAL LOCKING ACTUATOR (IN DOOR)
DRIVER'S DOOR SWITCH
EXCEPT CONV
FUSE 25
GLASS BREAKAGE SENSOR (IN CENTER ROOF LIGHT CONSOLE)
GRN WIRE
GRN/GRY WIRE
GRY WIRE
GRY/WHT WIRE
HOT AT ALL TIMES
INTERIOR FUSE BLOCK (BEHIND LEFT END OF DASH) FUSE 35
LEFT REAR DOOR SWITCH
LUGGAGE COMPARTMENT LIGHT SWITCH (IN LUGGAGE COMPT LOCK)
MICRO SWITCH BOOT LOCK (IN LUGGAGE COMPT LOCK, IN BOOT LID)
NON CONV CONV
PASSENGER'S CENTRAL LOCKING ACTUATOR (IN DOOR)
PASSENGER'S DOOR SWITCH
RED WIRE
RED/BLU WIRE
RED/WHT WIRE
RIGHT REAR DOOR SWITCH
TWICE CONTROL MODULE (UNDER DRIVER'S SEAT)
VIO WIRE
VIO/WHT WIRE
YEL WIRE
Go to component -> Anti-theft circuit -> GLASS BREAKAGE SENSOR (IN CENTER ROOF LIGHT CONSOLE)
