Porsche 911 Carrera 4S 991 (2011-2015) tire pressure monitoring control unit wiring diagram
This page shows the only wiring diagram for the component.tire pressure monitoring control unit, which is found in the car Porsche 911 Carrera 4S 991 (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
tire pressure monitoring control unit wiring diagram (1 of 1)
3.8L TWIN TURBO
ALL-WHEEL DRIVE CONTROL UNIT
ASHTRAY LIGHTING
BACKUP LIGHT SWITCH
BRIDGE PLUG (RELAY SUPPORT 1)
BRN WIRE
CHARGE AIR PRESSURE POSITIONER 1
CHARGE AIR PRESSURE POSITIONER 2
CIGAR LIGHTER
CLUTCH INTERLOCK SWITCH
COMBINED STEERING COLUMN MODULE
DIAGNOSTIC PLUG SOCKET
DME CONTROL UNIT
ELECTRONIC IGNITION LOCK
ENGINE COMPARTMENT FAN
EXTENDED SPOILER
GATEWAY CONTROL UNIT
HEADLIGHT WASHING FLUID PUMP
HEADLIGHT WASHING RELAY
IGNITION COIL 1
IGNITION COIL 2
IGNITION COIL 3
IGNITION COIL 4
IGNITION COIL 5
IGNITION COIL 6
INSTRUMENT CLUSTER
INTERIOR SENSOR
LEFT VENTS LIGHT
LIGHT SWITCH
PACKAGE TRAY SOCKET
PARKING BRAKE CONTACT SWITCH
PAS CONTROL UNIT
REAR WINDOW HEATER
REAR WINDOW HEATER RELAY
RIGHT TAILLIGHT ASSEMBLY
SOCKET 2
SPOILER SWITCH
SPORT CHRONO
TIRE PRESSURE MONITORING CONTROL UNIT
VEHICLE ELECTRICAL SYSTEM CONTROL UNIT
WHT WIRE
Go to component -> Ground distribution circuit, w/ turbo (2 of 4) -> TIRE PRESSURE MONITORING CONTROL UNIT
