Pontiac Vibe II (2008-2010) (engine harness) exterior lights system wiring diagram
This page shows the only wiring diagram for the component.(engine harness) exterior lights system, which is found in the car Pontiac Vibe II (2008-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(engine harness) exterior lights system wiring diagram (1 of 1)
54 56 PNP SW NEUTRAL SIG PNP SW DRIVE SIG PNK WIRE
73 53 PNP SWITCH PARK SIG BACKUP LAMP SW SIG
9 7 PNK WIRE
AUTOMATIC TRANSMISSION FLUID TEMPERATURE (TFT) SENSOR
AUTOMATIC TRANSMISSION SHIFT LEVER
BLK WIRE
BRN WIRE
COMPUTER DATA LINES SYSTEM
DK BLU WIRE
DK GRN WIRE
ECU-IG 1 FUSE 6
ECU-IG 2 FUSE 7
ETCS FUSE
GRY WIRE
HOT AT ALL TIMES UNDERHOOD FUSE BLOCK (LEFT SIDE OF ENGINE COMPT)
HOT W/ IGN 1 RELAY ENERGIZED
I/P FUSE BLOCK (LEFT END OF DASH)
LT BLU WIRE
LT GRN WIRE
ORG/ WIRE
PARK/NEUTRAL POSITION (PNP) SWITCH (ON TRANSMISSION)
PNK WIRE
PNK/DK GRN WIRE
PNP SWITCH LOW SIG
POWERTRAIN CONTROL MODULE (PCM) (LEFT SIDE OF ENGINE COMPT)
RED WIRE
S-D
SHIFT SHIFT SOLENOID SOLENOID VALVE VALVE (SSV) DSL
SHIFT SOLENOID VALVE
SHIFT SOLENOID VALVE (SSV) SLT
SHIFT SOLENOID VALVE (SSV) SR
SLT LOW CONTROL SLT HIGH CONTROL SLT HIGH CONTROL
TRANSMISSION CONNECTOR
VIO WIRE
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> 2.4l vin 0, a/t circuit, 5 speed a/t -> (ENGINE HARNESS) EXTERIOR LIGHTS SYSTEM
