Pontiac Vibe I facelift (2002-2008) (at front of engine compt, behind radiator) wiring diagram
This page shows the only wiring diagram for the component.(at front of engine compt, behind radiator), which is found in the car Pontiac Vibe I facelift (2002-2008). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(at front of engine compt, behind radiator) wiring diagram (1 of 1)
1.8L (VIN 8) FWD 1.8L (VIN L) AWD
A/C PRESSURE SW
BLK/RED WIRE
BLK/WHT WIRE
BLU/WHT WIRE
BRN WIRE
CLOSED BETWEEN 28 PSI, 455 PSI
ECT INPUT
ECU-IG FUSE
FAN 1 RELAY
FAN 1 RLY CTRL
FAN 2 RELAY
FAN 2 RLY CTRL
HOT AT ALL TIMES
HOT IN RUN OR START
LT GRN WIRE
LT GRN/BLK WIRE
OPEN BELOW 178 PSI CLOSED ABOVE 220 PSI
POWERTRAIN CONTROL MODULE (PCM) (BEHIND RIGHT SIDE OF DASH)
RADIATOR FAN MOTOR
RADIATOR FAN RESISTOR
RDI FAN FUSE
SENSOR GND
UNDERHOOD FUSE BLOCK (LEFT SIDE OF ENGINE COMPARTMENT, MOUNTED TO INNER FENDER)
WHT WIRE
WHT/BLK WIRE
WHT/RED WIRE
YEL WIRE
Go to component -> Cooling fan circuit -> (AT FRONT OF ENGINE COMPT, BEHIND RADIATOR)
