Pontiac Montana I (1997-2005) turn signal/ multifunction switch wiring diagram
This page shows the only wiring diagram for the component.turn signal/ multifunction switch, which is found in the car Pontiac Montana I (1997-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
turn signal/ multifunction switch wiring diagram (1 of 1)
1872 39 43 PNK WIRE
BATTERY GROUND
BLK WIRE
BLK/WHT WIRE
BLU WIRE
BODY CONTROL MODULE (BCM) (BELOW RIGHT SIDE OF DASH)
CHIME CONTROL
CHIME CTRL
CTSY/ LAMP FUSE
DK GRN WIRE
DK GRN/WHT WIRE
DRIVER DOOR LOCK ACTUATOR
DRIVER'S SEAT BELT SWITCH (INSIDE RIGHT HALF OF DRIVER'S SEAT BELT)
ENGINE CONTROLS SYSTEM
GRN WIRE
GROUND
HEAD OFF PARK
HEADLAMP SWITCH
HEADLIGHTS SYSTEM
HOT AT ALL TIMES
HOT IN ACCY OR RUN
HOT IN RUN, BULB TEST OR START
I/P FUSE BLOCK (RIGHT SIDE OF DASH, IN RIGHT FRONT DOOR OPENING)
IGN 1 FUSE
IGNITION KEY ALARM SWITCH (CLOSED W/KEY IN IGNITION)
INSTRUMENT PANEL CLUSTER (IPC)
LOGIC IGN
LT BLU WIRE
LT GRN WIRE
MALL CLUSTER FUSE
NCA WIRE
ORG/ WIRE
PNK WIRE
POWER DISTRIBUTION SYSTEM
SEAT BELT INDICATOR
SUPPLEMENTAL RESTRAINTS SYSTEM
TAN WIRE
TURN SIGNAL/ MULTIFUNCTION SWITCH
VSS
W/ VALVE VAN W/O VALVE VAN
WHT WIRE
YEL WIRE
Go to component -> Warning systems circuit -> TURN SIGNAL/ MULTIFUNCTION SWITCH
