Oldsmobile Silhouette I (1989-1996) cruise enable wiring diagram
This page shows the only wiring diagram for the component.cruise enable, which is found in the car Oldsmobile Silhouette I (1989-1996). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
cruise enable wiring diagram (1 of 1)
BLK WIRE
BRN WIRE
BRN/WHT WIRE
CONNECTED TO THROTTLE LINKAGE
CRUISE CONTROL MODULE (BEHIND I/P, LEFT OF STEERING COLUMN)
CRUISE CONTROL SERVO (ENGINE COMPARTMENT, MOUNTED TO LEFT WHEELHOUSE)
CRUISE CONTROL SWITCH
CRUISE ENABLE
DK BLU WIRE
DK BLU/WHT WIRE
FUSE BLOCK
GROUND
GRY WIRE
GRY/BLK WIRE
HOT IN RUN IGN FUSE
IGN PULSES PER MILE OUTPUT
LT BLU WIRE
LT BLU/BLK WIRE
LT GRN WIRE
NCA WIRE
OFF
OFF R/A ON
PEDAL SUPPORT)
PPL
R/A ON
SERVO POSITION SENSOR (SPS)
SET-
STOPLAMP/ CRUISE BRAKE SWITCH
TAN WIRE
TRANSAXLE
VACUUM ACTUATOR
VACUUM RELEASE PORT
VACUUM SOURCE
VACUUM VALVE
VARIABLE A/C SIGNAL
VEHICLE SPEED SENSOR
VEHICLE SPEED SENSOR BUFFER (BEHIND I/P COMPARTMENT, ABOVE CONVENIENCE CENTER)
VENT
VENT VALVE
VENT VALVE CONTROL VEHICLE SPEED INPUT
VSS INPUT
WHT WIRE
YEL WIRE
Go to component -> 3.1l (vin d), cruise control circuit -> CRUISE ENABLE
