Oldsmobile Achieva I (1991-1997) ppl 420 or wiring diagram
This page shows the only wiring diagram for the component.ppl 420 or, which is found in the car Oldsmobile Achieva I (1991-1997). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
ppl 420 or wiring diagram (1 of 1)
1995 VFTC
A/T
BLK WIRE
BLK/WHT WIRE
BRAKE IN GROUND IGN SIG BRAKE SIG CRUISE ENGAGE OUT VSS IN
BRAKE SWITCH (BEHIND I/P, ON BRAKE PEDAL SUPPORT)
BRN WIRE
BRN/WHT 379 WIRE
BRN/WHT WIRE
CRUISE CONTROL CLUTCH SWITCH (BEHIND I/P, ON BRAKE PEDAL SUPPORT)
CRUISE CONTROL MODULE (CENTER REAR OF ENGINE COMPARTMENT)
DK BLU WIRE
DK GRN WIRE
DK GRN/WHT WIRE
ERLS FUSE
FUSE BLOCK
GRY WIRE
GRY/BLK WIRE
HOT AT ALL TIMES STOP/ HAZ FUSE
HOT IN RUN, BULB TEST OR START CRUISE FUSE
LT BLU WIRE
LT BLU/BLK WIRE
M/T
MULTI-FUNCTION LEVER
OFF ON CRUISE SWITCH R/A
OFF SET SWITCH ON RESUME/ ACCEL SWITCH R/A
ON/OFF SIG SET/COAST SIG RESUME/ACCEL SIG
ORG/ WIRE
PNK PNK WIRE
PNK WIRE
POWERTRAIN CONTROL MODULE (PCM) (RIGHT UPPER I/P, ATTACHED TO BRACKET)
PPL
PPL (OR
PPL 420 OR
PPL A/T
PPL OR BRN WIRE
PPL TRANSMISSION SYSTEM
VIN D VIN M
WHT WIRE
Go to component -> Cruise control circuit -> PPL 420 OR
