Oldsmobile Achieva I (1991-1997) ect sensor in pcm ground brake switch in Wiring diagram
This page shows the only wiring diagram for the component.ect sensor in pcm ground brake switch in, which is found in the car Oldsmobile Achieva I (1991-1997). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram ect sensor in pcm ground brake switch in (1 of 1)
1-2 CTRL SOL TCC PWM SOL
2-3 CTRL SOL
BATTERY IN SENSOR RETURN PCM GROUND TP SENSOR IN 1-2 SHIFT SOL
BLK WIRE
BLK/WHT WIRE
BRAKE SWITCH (BEHIND LEFT SIDE OF DASH)
BRN WIRE
BRN/WHT WIRE
DATA LINK CONNECTOR (UNDER LEFT SIDE OF DASH)
DK BLU WIRE
DK GRN/WHT WIRE
ECT SENSOR IN PCM GROUND BRAKE SWITCH IN
ENGINE COOLANT TEMPERATURE SENSOR (LEFT REAR OF ENGINE)
ERLS FUSE
FUSE BLOCK
FUSIBLE LINK A (22 GA-
GAUGES FUSE
GRY WIRE
HOT AT ALL TIMES
HOT IN RUN, BULB TEST OR START
INSTRUMENT CLUSTER
INSTRUMENT CLUSTER SYSTEM
MALFUNCTION INDICATOR LAMP
NCA WIRE
OLDS
PCM FUSE
PCM GROUND PCM GROUND
PNK WIRE
PONTIAC
POWERTRAIN CONTROL MODULE (RIGHT SIDE OF ENGINE COMPT)
PPL
RED WIRE
STARTER SOLENOID
TAN WIRE
TAN/BLK WIRE
TAN/WHT WIRE
TCC SOL
THROTTLE POSITION SENSOR (THROTTLE BODY)
TRANS- AXLE
VEHICLE SPEED SENSOR (LOWER RIGHT REAR OF ENGINE COMPT, ON TRANSAXLE)
WHT WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> 2.3l (vin d), transmission circuit, with 4 speed a/t -> ECT SENSOR IN PCM GROUND BRAKE SWITCH IN
