Nissan Versa II (2012-2014) security ind output immob one way communication Wiring diagram
This page shows the only wiring diagram for the component.security ind output immob one way communication, which is found in the car Nissan Versa II (2012-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram security ind output immob one way communication (1 of 1)
39 40 39 40 CAN-H CAN-L
70 57 67 BAT (F/L) BAT (FUSE) GND
84 83 CAN-H CAN-L
BCM (BODY CONTROL MODULE) (BEHIND LEFT END OF DASH)
BLK WIRE
BLU WIRE
BRN WIRE
COMBINATION METER
COMPUTER DATA LINES SYSTEM PNK WIRE
COMPUTER PNK DATA LINES SYSTEM WIRE
ECM (ENGINE CONTROL MODULE) (LEFT REAR OF ENGINE COMPT)
FUSE
GRN WIRE
HOT AT ALL TIMES
HOT AT ALL TIMES FUSE BLOCK (J/B) FUSE
HOT IN ON OR START
IGN SW
IMMOB TOW WAY COMMUNICATION
LT GRN WIRE
NATS ANTENNA AMPLIFIER (BEHIND (RIGHT SIDE SIDE END OF DASH) OF STEERING COLUMN)
ORG/ WIRE
PNK WIRE
RED WIRE
SECURITY IND
SECURITY IND OUTPUT IMMOB ONE WAY COMMUNICATION
YEL WIRE
Go to component -> Immobilizer circuit -> SECURITY IND OUTPUT IMMOB ONE WAY COMMUNICATION
