Nissan Versa II (2012-2014) bat saver Wiring diagram
This page shows the only wiring diagram for the component.bat saver, which is found in the car Nissan Versa II (2012-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram bat saver (1 of 1)
13 12 46 45 DOOR SW (RR) DOOR SW (AS) PNK WIRE
15 18 PPL
38 37 IGN SW KEY SW
39 40 CAN-H CAN-L PNK WIRE
48 47 DOOR SW (RL) DOOR SW (DR)
BAT (F/L)
BAT FUSE
BAT SAVER
BLK WIRE
BLU WIRE
BODY CONTROL MODULE (BCM) (BEHIND LEFT
BRN WIRE
COMPUTER DATA LINES SYSTEM
DOOR
END OF DASH)
FUSE 12
FUSE 2
FUSE 8 (UNDER LEFT END OF DASH)
FUSE BLOCK (J/B)
FUSE, FUSIBLE LINK BOX (LEFT REAR OF ENGINE COMPT)
FUSIBLE LINK G
GRN WIRE
HOT AT ALL TIMES
HOT IN ON OR START
INTERIOR ROOM LAMP
LT BLU WIRE
LT GRN WIRE
LUGGAGE LAMP
MAP LAMP (IF EQUIPPED)
OFF ON
ORG/ WIRE
PNK WIRE
PPL
RED WIRE
RIGHT FRONT DOOR SWITCH (RIGHT FRONT "B" PILLAR)
RIGHT REAR DOOR SWITCH (RIGHT REAR "C" PILLAR)
ROOM LAMP OUT
TRUNK LID SWITCH
TRUNK/GLASS PNK HATCH SW WIRE
W/ INTELLIGENT KEY SYSTEM
W/O INTELLIGENT KEY SYSTEM
WHT WIRE
YEL WIRE
Go to component -> Courtesy lamps circuit -> BAT SAVER
