Nissan Titan I facelift (2007-2015) security ind combination meter Wiring diagram
This page shows the only wiring diagram for the component.security ind combination meter, which is found in the car Nissan Titan I facelift (2007-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram security ind combination meter (1 of 1)
57 70 67 BAT (FUSE) BAT (F/L) GND (POWER)
94 86 CAN-H CAN-L PNK WIRE
BCM (BODY CONTROL MODULE) (BEHIND CENTER OF DASH)
BLK WIRE
BLU WIRE
BLU/WHT WIRE
BRN WIRE
CAN- HORN RLY CPU
COMPUTER DATA LINES SYSTEM
ECM (ENGINE CONTROL MODULE) (AT RIGHT SIDE OF ENGINE COMPT)
ENGINE COMPT)
FUSE 22 FUSE 19
FUSE 25
FUSE 53 FUSE 52
FUSE 53 H/LP LO HI
FUSE 59
FUSE BLOCK (J/B) (BEHIND RIGHT END OF DASH)
FUSE, FUSIBLE LINK BOX (AT RIGHT REAR OF
FUSIBLE LINK F
GND CAN- (SIGNAL)
GND POWER
GRN WIRE
GRN/ORG WIRE
GRN/WHT WIRE
H/LP
HEADLIGHTS SYSTEM
HORN (AT RIGHT FRONT
HORN RELAY (IN FUSE, FUSIBLE LINK BOX)
HORNS SYSTEM
HOT AT ALL TIMES
HOT IN ON OR START
HOT IN ON OR START FUSE, RELAY BOX (AT RIGHT REAR OF ENGINE COMPT)
IG B+
IGNITION RELAY
NATS ANTENNA AMPLIFIER (BEHIND LEFT SIDE OF DASH)
OF DASH)
OF ENGINE COMPT)
PNK WIRE
RED WIRE
RED/WHT WIRE
SECURITY IND COMBINATION METER
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
YEL/RED WIRE
Go to component -> Immobilizer circuit -> SECURITY IND COMBINATION METER
