Nissan Tiida C11 facelift (2010-2013) ppl avcc-tps Wiring diagram
This page shows the only wiring diagram for the component.ppl avcc-tps, which is found in the car Nissan Tiida C11 facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram ppl avcc-tps (1 of 1)
1.8L
ACCEL/RES SWITCH
ACCELERATOR PEDAL POSITION SENSOR
ASCD BRAKE SWITCH (1.8L)
ASCD CLUTCH SWITCH
ASCD STEERING SWITCH (1.8L)
ASCDSW
BLK WIRE
BLU WIRE
BNC SW
BRAKE SW
CAN H PNK CAN L PPL WIRE
CAN L
CAN-H
CAN-H PNK CAN-L WIRE
CANCEL SWITCH
CLOSE
COAST/ SET SWITCH
COMBINATION METER
COMPUTER DATA LINES SYSTEM
CRUISE IND
CVT
ECM (ENGINE CONTROL MODULE)
EXCEPT M/T
FUSE 13
FUSE 2
FUSE 3
FUSE 49
FUSE 7
FUSE BLOCK (J/B)
GND-ASCDSW
GND-TPS
GRN WIRE
GRY WIRE
HOT AT ALL ALL TIMES
HOT IN ON OR START
IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)
LT BLU WIRE
LT GRN WIRE
M/T
MOTOR 1
ON/OFF (MAIN) SWITCH
ORG/ WIRE
PNK MOTOR 2 WIRE
PNK WIRE
PPL
PPL AVCC-TPS
PRI SPD SENS
PRIMARY SPEED SENSOR
RED WIRE
SEC SPD SENS
SECONDARY SPEED SENSOR
SENS GND
SENSOR 1
SENSOR 2
SENSOR 2 ELECTRIC THROTTLE CONTROL ACTUATOR
SPD SENS
SPD SENS (GND)
SPIRAL CABLE (COMBINATION SWITCH)
STOP LAMP SWITCH
TRANSMISSION CONTROL MODULE (TCM)
UNIFIED METER CONTROL UNIT
VEHICLE SPEED SENSOR
WHT WIRE
YEL WIRE
Go to component -> Cruise control circuit -> PPL AVCC-TPS
