Nissan Sentra B17 facelift (2015-2019) inhibit cut Wiring diagram
This page shows the only wiring diagram for the component.inhibit cut, which is found in the car Nissan Sentra B17 facelift (2015-2019). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram inhibit cut (1 of 1)
ACCELERATOR PEDAL POSITION SENSOR
BLK WIRE
BLK/YEL WIRE
BLU WIRE
BRN WIRE
CAN L
CAN-H
COMPUTER DATA LINES SYSTEM
CRANKSHAFT POSITION SENSOR (POS)
CVT
ECM RELAY
ELECTRIC THROTTLE CONTROL ACTUATOR (ON THROTTLE BODY)
EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE
FUEL LEVEL SENSOR UNIT, FUEL PUMP
FUEL PUMP
FUEL PUMP RELAY
FUEL TANK TEMPERATURE SENSOR
FUSE 33
FUSE 46
FUSE 50
FUSE 51
FUSE 52
FUSE 54
GND SIG
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR
HOT W/ IGNITION RELAY 1 ENERGIZED
INHIBIT CUT
IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)
LT BLU WIRE
LT GRN WIRE
ORG/ WIRE
PNK WIRE
PPL
RED WIRE
SENSOR 1
SENSOR 2
STARTER RELAY
THROTTLE CONTROL MOTOR
THROTTLE CONTROL MOTOR RELAY
THROTTLE POSITION SENSOR
TRANSMISSION RANGE SWITCH
WHT WIRE
YEL WIRE
Go to component -> Wiring diagram engine performance 1.8l (2 of 4) -> INHIBIT CUT
