Nissan Rogue II (2013-2016) rear height sensor (right rear wheelwell) wiring diagram
This page shows the only wiring diagram for the component.rear height sensor (right rear wheelwell), which is found in the car Nissan Rogue II (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
rear height sensor (right rear wheelwell) wiring diagram (1 of 1)
33 34 36 37 38 39 I CSW 5 O CSW 5 I CSW 3 I CSW 4 I CSW 1 I CSW 2
84 85 86 87 O CSW 2 O CSW 1 O CSW 3 O CSW 4
AMP
BCM (BODY CONTROL MODULE) (BEHIND LEFT END OF DASH)
BLK WIRE
BLU WIRE
BRN WIRE
CAN L
CAN-H
COMBINATION METER
COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH)
COMPUTER DATA LINES SYSTEM
FRONT COMBINATION LAMP LH (HEADLAMP AIMING MOTOR)
FRONT COMBINATION LAMP RH (HEADLAMP AIMING MOTOR)
FUSE
FUSE 13
FUSE BLOCK (J/B) (LEFT END OF DASH)
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
I PWR ECU
I SHORTING PIN
IGN BAT BAT
IGNITION RELAY 1
LT BLU WIRE
LT GRN WIRE
PNK CAN-L WIRE
PNK WIRE
PPL/BRN WIRE
PPL/GRN WIRE
REAR HEIGHT SENSOR (RIGHT REAR WHEELWELL)
RIGHT END OF DASH)
TAN WIRE
UNIFIED METER CONTROL UNIT WITH INFORMATION DISPLAY
VIO WIRE
WHT WIRE
YEL WIRE
Go to component -> Headlamp aiming circuit, with led headlamps -> REAR HEIGHT SENSOR (RIGHT REAR WHEELWELL)
