Nissan Rogue II (2013-2016) rear data link cargo connector power socket Wiring diagram
This page shows the only wiring diagram for the component.rear data link cargo connector power socket, which is found in the car Nissan Rogue II (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram rear data link cargo connector power socket (1 of 1)
3 4 W/O BOSE AUDIO W/ BOSE AUDIO
AUDIO UNIT (W/O NAVIGATION)
AV CONTROL UNIT (W/ NAVIGATION)
AWD CONTROL MODULE
BACK-UP LAMP ASSEMBLY LH
BACK-UP LAMP ASSEMBLY RH
BEHIND LEFT QUARTERPANEL)
BLU WIRE
BRN WIRE
FROM FUSIBLE LINK C (FUSIBLE LINK BOX (BATTERY)) (DIAGRAM 1 OF 6)
FROM FUSIBLE LINK D (FUSIBLE LINK BOX (BATTERY)) (DIAGRAM 1 OF 6)
FROM FUSIBLE LINK E (FUSIBLE LINK BOX (BATTERY)) (DIAGRAM 1 OF 6)
FRONT COMBINATION LAMP LH
FRONT COMBINATION LAMP RH
FRONT FOG LAMP LH
FRONT FOG LAMP RH
FUSE 13 FUSE 18
FUSE 2 FUSE 6
FUSE 26
FUSE 41
FUSE 9
FUSE BLOCK (J/B) (LEFT END OF DASH)
GRN WIRE
GRY WIRE
LICENSE PLATE LAMP LH
LICENSE PLATE LAMP RH
LT BLU WIRE
LT GRN WIRE
NATS AWD ANTENNA CONTROL AMP MODULE (W/O INTELLIGENT KEY SYSTEM)
PNK WIRE
PPL/BLU WIRE
PPL/BRN WIRE
PPL/GRN WIRE
PPL/RED WIRE
PPL/YEL WIRE
QUARTER PANEL)
REAR COMBINATION LAMP LH
REAR COMBINATION LAMP RH
REAR DATA LINK CARGO CONNECTOR POWER SOCKET
RED WIRE
ROOM COMBINATION LAMP RELAY METER
SMART FET
STARTER CUT RELAY (IN FUSE,FUSIBLE LINK BOX AND RELAY BOX 2)
STARTER MOTOR
STARTER RELAY
TAN WIRE
TO FRONT WIPER RELAY (IPDM E/R) (DIAGRAM 5 OF 6)
TO FUSE 14 (FUSE BLOCK (J/B)) (DIAGRAM 3 OF 6)
TO IGNITION RELAY-1 (IPDM E/R) (DIAGRAM 6 OF 6)
TRANSMISSION RANGE SWITCH
VIO WIRE
W/ HALOGEN HEADLAMPS W/ LED HEADLAMPS
WHT WIRE
YEL WIRE
Go to component -> Power distribution circuit (2 of 6) -> REAR DATA LINK CARGO CONNECTOR POWER SOCKET
