Nissan Rogue II (2013-2016) occupant classification system sensor fl Wiring diagram
This page shows the only wiring diagram for the component.occupant classification system sensor fl, which is found in the car Nissan Rogue II (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram occupant classification system sensor fl (1 of 1)
AIR BAG
BLK WIRE
BLU WIRE
BRN WIRE
BRN/WHT WIRE
CAN-L CAN-H
COLUMN)
COMBINATION METER
CRASH ZONE SENSOR (CENTER FRONT OF ENGINE COMPARTMENT)
DASH)
DATA LINK CONNECTOR (UNDER LEFT SIDE OF DASH)
DR BELT SW
DRIVER AIR BAG MODULE
FRONT DOOR SATELLITE SENSOR LH (CENTER OF FRONT LEFT DOOR)
FRONT DOOR SATELLITE SENSOR RH (CENTER OF FRONT RIGHT DOOR)
GRN WIRE
GRY WIRE
IGN
IND
LOAD SENS REAR INNER GROUND LOAD SENS REAR INNER SIGNAL LOAD SENS REAR INNER VCC
LT BLU WIRE
LT GRN WIRE
NCA WIRE
OCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT (UNDER FRONT PASSENGER'S SEAT)
OCCUPANT CLASSIFICATION SYSTEM SENSOR FL
OCCUPANT CLASSIFICATION SYSTEM SENSOR RL
PNK WIRE
PPL/BRN WIRE
PPL/GRN WIRE
PPL/YEL WIRE
RED WIRE
RED/BLK WIRE
RED/BRN WIRE
RIGHT END OF DASH)
SEAT BELT
SEAT BELT BUCKLE SWITCH RH
SHIELD
SPIRAL CABLE
TAN WIRE
UNIFIED METER CONTROL UNIT
VIO WIRE
VIO/YEL WIRE
WHT WIRE
WHT/BLU WIRE
YEL WIRE
Go to component -> Supplemental restraints circuit (2 of 2) -> OCCUPANT CLASSIFICATION SYSTEM SENSOR FL
