Nissan Rogue II (2013-2016) con recognition sig engine coolant temp sig Wiring diagram
This page shows the only wiring diagram for the component.con recognition sig engine coolant temp sig, which is found in the car Nissan Rogue II (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram con recognition sig engine coolant temp sig (1 of 1)
21 22 23 24 25 26 27 28 WATER TEMP RR/DEF SW RR/DEF F/B SENS GND INT SENS
28 27 39 BLOWER FAN SW AIRCON SW CAN-H CAN-L
AIR MIX DOOR MOTOR (RIGHT SIDE OF HVAC UNIT)
AMBIENT SENSOR
AMP
AUTO AMPLIFIER
BCM (BODY CONTROL MODULE) (BEHIND LEFT END OF DASH)
BLK WIRE
BLOWER MOTOR (LEFT SIDE OF HVAC UNIT)
BLOWER RELAY
BLU WIRE
BRN WIRE
CAN-H- CAN-L-
COMBINATION METER
COMPUTER DATA LINES SYSTEM PNK WIRE
CON RECOGNITION SIG ENGINE COOLANT TEMP SIG
DEFOGGER SYSTEM
FAN CONTROL AMPLIFIER (LEFT SIDE OF
FR/FAN OUT FR/FAN F/B FAN ON FR/IGN 2
FUSE 1
FUSE 15
FUSE 16
FUSE 8
FUSE BLOCK (J/B) (BEHIND LEFT END OF DASH)
FUSIBLE LINK D
FUSIBLE LINK HOLDER
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
HVAC UNIT)
IGNITION SWITCH
IN-VEHICLE SENSOR
INCAR SENS AMB SENS SUN SENS LIGHT- LIGHT+
INTAKE SENSOR SUNLOAD SENSOR (ON CONDENSER)
INTERIOR LIGHTS SYSTEMS
LT BLU WIRE
LT GRN WIRE
MODE DOOR MOTOR (LEFT SIDE OF HVAC UNIT)
OFF
OUTSIDE TEMP PWR
PNK WIRE
PPL
PPL LAN (-)
RED WIRE
WHT WIRE
YEL WIRE
Go to component -> Automatic a/c circuit (1 of 2) -> CON RECOGNITION SIG ENGINE COOLANT TEMP SIG
