Nissan Rogue II (2013-2016) (base of left "a" pillar) wiring diagram
This page shows the only wiring diagram for the component.(base of left "a" pillar), which is found in the car Nissan Rogue II (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(base of left "a" pillar) wiring diagram (1 of 1)
171 170 I GND 2 I GND 1
6 11 PNK WIRE
BCM (BODY CONTROL MODULE) (BEHIND LEFT END OF DASH)
BLK WIRE
BLU WIRE
BRN WIRE
CIRCUIT BREAKER-2 (LOWER CENTER OF DASH)
CLOSE
COMBINATION METER
FRONT DOOR SWITCH LH (LEFT "B" PILLAR)
FRONT DOOR SWITCH RH
FUSE
FUSE 14 FUSE 7 OF DASH)
FUSE BLOCK J/B (LEFT END
FUSE/ FUSIBLE LINK BOX AND RELAY BOX 1 (LEFT SIDE OF ENGINE COMPARTMENT)
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
I PWR ECU
I SHORTING PIN
LT BLU WIRE
LT GRN WIRE
MOONROOF MOTOR ASSEMBLY
MOONROOF SWITCH
O WL AUTHORIZATION RL
PNK WIRE
POWER WINDOW RELAY (LOWER CENTER OF DASH)
PUSH
RED WIRE
RIGHT END OF DASH)
SUNSHADE MOTOR ASSEMBLY
UNIFIED METER CONTROL UNIT WITH INFORMATION DISPLAY
VIO WIRE
WHT WIRE
YEL WIRE
Go to component -> Power top/sunroof circuit -> (BASE OF LEFT "A" PILLAR)
