Nissan Rogue II (2013-2016) alvu sbat can-h can-l Wiring diagram
This page shows the only wiring diagram for the component.alvu sbat can-h can-l, which is found in the car Nissan Rogue II (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram alvu sbat can-h can-l (1 of 1)
100 99 COMPUTER DATA LINES SYSTEM CAN-H PNK CAN-L WIRE
9 10 BATTERY + GND
ABS ACTUATOR, ELECTRIC UNIT (CONTROL UNIT) (RIGHT REAR OF ENGINE COMPARTMENT)
ALVU SBAT CAN-H CAN-L
BLK WIRE
BLU WIRE
CAN L
CAN-H
COMBINATION METER
COMPUTER DATA LINES SYSTEM
COMPUTER DATA LINES SYSTEM PNK WIRE
ECM (LEFT SIDE OF ENGINE COMPARTMENT) COMPUTER DATA LINES SYSTEM
EPS CONTROL UNIT (BEHIND LEFT SIDE OF DASH)
EPS IGN
EPS MOTOR (ON STEERING COLUMN)
FUSE
FUSE/ FUSIBLE LINK, FUSIBLE RELAY BOX 1 LINK G (LEFT SIDE OF ENGINE COMPARTMENT)
FUSIBLE LINK I
GRN WIRE
HOT AT ALL TIMES
HOT IN ON OR START
HOT IN ON OR START FUSE BLOCK (J/B) (LEFT END OF DASH)
IG SIGNAL
LT BLU WIRE
NCA WIRE
PNK 1 2 3 4 5 6 7 8 CAN-L CAN-H WIRE
PNK WIRE
POSITION SIG
PPL/BRN WIRE
PPL/GRN WIRE
RED WIRE
RIGHT END OF DASH)
TORQUE SENS REF VOLTAGE
TORQUE SENSOR
UNIFIED METER CONTROL UNIT WITH INFORMATION DISPLAY
WHT WIRE
YEL WIRE
Go to component -> Electronic power steering circuit -> ALVU SBAT CAN-H CAN-L
