Nissan Rogue I facelift (2010-2013) vch speed sig (2-pulse) microphone power wiring diagram
This page shows the only wiring diagram for the component.vch speed sig (2-pulse) microphone power, which is found in the car Nissan Rogue I facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
vch speed sig (2-pulse) microphone power wiring diagram (1 of 1)
2 1 4 (OR SHIELD) MICROPHONE SIG (-) MICROPHONE SIG (+) MICROPHONE PWR
2 8 9 3 SHIELD
7 8 SHIELD
AV COMM SIG (H) AV COMM SIG (L)
BATTERY
BLK WIRE
BLU WIRE
BRN WIRE
COMBINATION METER
COMBINATION SWITCH (SPIRAL CABLE) (TOP OF STEERING COLUMN)
COMPUTER DATA LINES SYSTEM PNK WIRE
CONTROL SIGNAL CONTROL SIGNAL CONTROL SIGNAL CONTROL SIGNAL
FUSE 1 (BEHIND LEFT END OF DASH)
FUSE BLOCK (J/B)
GRY WIRE
HOT IN ON OR START
IGN 4 5 6 GND
LT BLU WIRE
LT GRN WIRE
MICROPHONE
MICROPHONE SIG (+) MICROPHONE SIG (-)
NCA WIRE
ORG/ WIRE
RED WIRE
SEEK DOWN
SEEK UP
SHIELD
SHIELD 69 59 58
SOUND SIGNAL (+) SOUND SIGNAL (-)
SOURCE
STEERING SWITCH
TEL ADAPTER UNIT
TEL ANTENNA
TEL ANTENNA SIGNAL
TELE- PHONE END
VCH SPEED SIG (2-PULSE) MICROPHONE POWER
VCH SPEED SIG (8-PULSE) CAN-H CAN-L 31 21 22
VOICE/ TEL
VOLUME-
WHT WIRE
YEL WIRE
Go to component -> Radio circuit, base with satellite radio (3 of 3) -> VCH SPEED SIG (2-PULSE) MICROPHONE POWER
