Nissan Rogue I facelift (2010-2013) 3 1 8 4 gnd ign can-l can-h Wiring diagram
This page shows the only wiring diagram for the component.3 1 8 4 gnd ign can-l can-h, which is found in the car Nissan Rogue I facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram 3 1 8 4 gnd ign can-l can-h (1 of 1)
3 1 8 4 GND IGN CAN-L CAN-H
4 5 2 6 VCC (POWER) SERIAL + GND SERIAL -
ABS ACTUATOR, ELECTRIC UNIT (CONTROL UNIT)
ABS, SLIP, VDC OFF, BRAKE IND
ASCD BRAKE SWITCH (ON BRAKE PEDAL BRACKET)
BLK WIRE
BLU WIRE
BRAKE FLUID LEVEL SWITCH
BRN WIRE
COMBINATION METER
COMPUTER DATA LINES SYSTEM
FR SENS VB CAN H FL SENS VB DIAG K
FUSE 1
FUSE 59
FUSE, FUSIBLE LINK, RELAY BOX (LEFT SIDE OF ENGINE COMPT)
FUSIBLE LINK H
FUSIBLE LINK I
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT AT ALL TIMES FUSE BLOCK (J/B) (BEHIND LEFT END OF DASH) FUSE 11
HOT IN ON OR START
LEFT FRONT WHEEL SENSOR
LEFT REAR WHEEL SENSOR
LT BLU WIRE
LT GRN WIRE
ORG/ WIRE
PARKING BRAKE SWITCH
PNK 22 21 27 26 CAN-L CAN-H BRAKE FLUID SW PARKING BRAKE SW WIRE
PNK WIRE
PPL
RED WIRE
RIGHT FRONT WHEEL SENSOR
RIGHT REAR WHEEL SENSOR
RL SENS SIG
RL SENS VB FL SENS SIG G GND PNK WIRE
RR SENS SIG IGN
RR SENS VB FR SENS SIG G CHECK
SHIELD
STEERING ANGLE SENSOR (ON STEERING COLUMN)
STOP LAMP SW CAN-L PNK WIRE
STOPLIGHT SWITCH (ON BRAKE PEDAL BRACKET)
TRANSMISSIONS SYSTEM
VDC OFF SWITCH
WHT WIRE
YAW RATE/SIDE/ DECEL G SENSOR
YEL WIRE
Go to component -> Anti-lock brakes circuit, with vdc -> 3 1 8 4 GND IGN CAN-L CAN-H
