Nissan Rogue I facelift (2010-2013) 23 3 1 2 21 22 gnd gnd batt ign can-h can-l Wiring diagram
This page shows the only wiring diagram for the component.23 3 1 2 21 22 gnd gnd batt ign can-h can-l, which is found in the car Nissan Rogue I facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram 23 3 1 2 21 22 gnd gnd batt ign can-h can-l (1 of 1)
2 4 1 SIG POWER GND PPL
20 19 18 39 40 4 3 2 5 6 32 33 34 35 36 TUNER SIG TUNER PWR SENS GND PPL
23 3 1 2 21 22 GND GND BATT IGN CAN-H CAN-L
70 57 67 BAT (F/L) BAT (FUSE) GND
BCM (BODY CONTROL MODULE) (BEHIND LEFT END OF DASH)
BLK WIRE
BLU WIRE
BRN WIRE
CAN-H CAN-L PNK WIRE
COMBINATION METER
COMBINATION SWITCH
COMPUTER DATA LINES SYSTEM
DR SW (DR)
DRIVER FRONT DOOR SWITCH (LEFT "B" PILLAR)
DRIVER SIDE FRONT TIRE PRESSURE SENSOR
END OF DASH)
FUSE 10
FUSE 3
FUSE 9
FUSE BLOCK (J/B) (BEHIND LEFT
FUSE, FUSIBLE LINK, RELAY BOX (LEFT SIDE OF ENGINE COMPT)
FUSIBLE LINK J
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
LEFT REAR TIRE PRESSURE SENSOR
LT GRN WIRE
ORG/ WIRE
PASSENGER SIDE FRONT TIRE PRESSURE SENSOR
PNK WIRE
PPL
RED WIRE
REMOTE KEYLESS ENTRY RECEIVER (TIRE PRESSURE RECEIVER)
RIGHT REAR TIRE PRESSURE SENSOR
TIRE PRESSURE PNK IND WIRE
WHT WIRE
YEL WIRE
Go to component -> Tire pressure monitoring circuit -> 23 3 1 2 21 22 GND GND BATT IGN CAN-H CAN-L
